6 steps
Double Egg Loop Knot
Heads up: we checked this page against published instructions for this knot, and the steps here don't match. We're rewriting them from those sources. Until then, please don't rely on these steps.
Two bait loops on the shank for a large egg cluster or two pieces of bait.
Use it for
Two bait loops on the shank for a large egg cluster or two pieces of bait.
This line
Snell a fluoro or mono leader. Braid on the shank slips and is easier for a fish to see.
Avoid when
Offset worm hooks you will Texas-rig at the eye.
All steps visible
Double Egg Loop Knot
These steps are being corrected. Don't follow them yet.
These steps are being corrected. Don't follow them yet.
Step 1
Pass the tag through the eye and lay it along the shank.
Step 2
Hold that tag. Start wrapping the standing line around the shank and the tag. 4 turns so far.
Step 3
Complete 8 wraps working down the shank toward the bend. Keep them touching.
Step 4
Leave two open loops off the shank so a large bait has two places to sit.
Step 5
Pass the standing line back through the eye from the same side the tag entered.
Step 6
Wet the wraps and pull until they lock in a tight band under the eye. Trim the tag.
The drawing follows this tying order. Pause, step, or scrub to stay with the words. The standing line runs to the reel. The tag is the short end you trim. Skin-hook means the point lies flat in the plastic, not out where grass can grab it.
Common mistakes
- Wraps that spiral apart instead of forming a band on the shank.
- Pulling so hard the line cuts a light fluoro leader.
Related tools